PDA

View Full Version : need hot rods crank bushing


crandles
06-27-2010, 11:51 AM
I am in need of the bushing that the pin goes through on a hot rods crank. Thought maybe someone would have a bad hotrods crank laying around.
09RappySe
06-27-2010, 08:20 PM
You can call hot rods....they will send one to you.
crandles
06-27-2010, 09:39 PM
I called them and they said they dont have them. Im going to try again tomorrow. Maybe ill get someone who knows what they are talking about. The guy I talked to didnt even no they had a bushing.. LOL
09RappySe
06-28-2010, 08:55 AM
When I talked to them, they said they make them as needed, I am sure they have the spec's for your application and can make you one....I ordered a 1X6" piece of bearing brass to make my own, but I have access to a machine shop.
09RappySe
06-29-2010, 07:39 AM
Did you get your bushing?
crandles
06-29-2010, 11:44 AM
No they said they are made with the rod. So they would have to waste a rod to get me one. They r suppose to call me back with the measurements. I dought that will happen.
09RappySe
06-29-2010, 06:43 PM
If you can get the spec's I still have some material left and would be happy to make you one and ship it to you, I don't know if you need it right away or not, but the offer is there if you need it, just let me know.


Jeff
crandles
06-30-2010, 10:31 AM
That would be awesome! Just got some measurements. He said it is 19.9X20.61 and .71mm thick. Let me no if that is what you need. Thanks
09RappySe
07-06-2010, 08:36 PM
Crandles,

Sent you a PM.
09RappySe
07-09-2010, 06:38 AM
I have your bushing done, PM me your address so I can ship it.

Jeff