Setting up extended a arms

[bodfper]

I just bought a set of used JB Racing +2 a arms on ebay and need a little bit of help. I have the a arms installed and just put the tires on today and checked the camber. What I did was take a large square and put it flat against the level concrete and butted it up to the center of the front rims. What I got is a 1 inch gap between the sidewall and square at the top of the tires. IS THIS GOOD? OR DO I NEED SOME ADJUSTING? If I need to adjust it what balljoint will need to be adjusted, lower or upper? Also how do I set the toe?

THANKS FOR ALL OF YOUR TIME IT IS GREATLY APPRECIATED!

[bodfper]

Any help??? I need this done before the 4th!!

[416racer]

I think 1" is a bit much of a gap,maybe 1/2 to 3/4 would be closer but it kinda depends on what you like, just play with it a bit. To set the toe measure half way up the tire in the front and back.You want it about 1/4"closer in the front. This is a simple explanation,there is alot of detailed info on this site.

[atv fan 28]

This should help you.:D

http://www.lsracing.com/img/Guide_21.pdf