new fuel mix screw

[rmcfadden68]

been looking from website to website. no luck. im lookin to buy an aftermarket air/fuel mix screw. tired of burnin myself. any ideas?

[dalejiw25]

"livin on the edge cause there`s no room left in the center" Hell, If you aint livin on the edge You're just takin up space.

[honda400ex2003]

I dont believe that there is one made for the ex carb. i think only for the 450r carbs. I may be wrong though, ill look for a bit and see what i can find. steve

[dalejiw25]

I've only seen the larger more user friendly ones for the FCR carbs.

http://www.magicracing.com/SRP-Keihin-FCR-Fuel-Mixture-Screw_p_1582.html

[CJM]

I been thinking of using some JB weld and putting perhaps a small screw or a knob from the back of a computer on there.

[rmcfadden68]

Originally posted by CJM
I been thinking of using some JB weld and putting perhaps a small screw or a knob from the back of a computer on there.
i think im gonna take a dremel and make it into a sloted screw. doesnt seem to be to difficult. im smarter than that there bloody screw

[honda400ex2003]

you could get a stock one from before 05 since they have a notch in them already. otherwise you could make a tool that is a D shape to fit it or notch it out on your 05. steve

[CJM]

I have one of the slotted ones already cause mine is an 00, it doesnt help at all cause the idle screw is RIGHT IN THE WAY!

[dalejiw25]

I took the bolt out of the Idle screw bracket and left it dangle. Then I bought a pilot screw adjusting tool and it fits right in. Problem solved. It's a good day to go whup on some 450s and Craptors hehe - Gotta go C-Yas !!!!

[bkelley]

Originally posted by dalejiw25
I've only seen the larger more user friendly ones for the FCR carbs.

http://www.magicracing.com/SRP-Keihin-FCR-Fuel-Mixture-Screw_p_1582.html Is this only for FCR carbs? Or would it fit in my 42mm?