jb +2 a arms ????

[bodfper]

I just bought a used set of JB +2 a arms off of ebay for $230 bucks. I have never replaced a arms on a quad so Im not sure what has to be done. I have one side torn apart and I am ready to start putting it back together but I have a couple of questions.

One of the tie rods is slightly bent just where the threads are. Is this ok?

What do I have to do when installing old tie rod ends to +2 tie rods?

Was this a good buy?

Thanks, all appreciated.

[a4guy]

Send them to me for free and I will let you know how they do. haha

Should be able to bend it straight and it will be fine. Just use a vice or something but don't ruin the threads.

[bodfper]

When I install the old tie rod ends to the new tie rods how do I know when to stop tightening them. How do I align the tires to be the same and should they be towed in a little?

[JOHNDOE83]

stand the atv on the grab bar, and use a level on the rims to get them straight, once they are straight if you want you can turn the tie rod a 1/4 turn to toe it in, I left mine straight. each time you tighten or lossen, double check your handle bars and make sure they are still straight.