a arm bushings?

[levonskinator]

Which set of a arm bushings would you prefer? Thanks in advance


http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=290369465291&viewitem=&sspagename=STRK:MEWAX:IT#ht_1566wt_931

or

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=380235969845&viewitem=&sspagename=STRK:MEWAX:IT#ht_500wt_817

[honda400ex2003]

i would prefer the first. imo the bearings are better than any teflon could be but the tef may seal a bit better if you dont the seals on tight. I would get the stock stuff and just rebuild the arms with that. they are the best ones imo anyway. it may cost a bit more but it is worth it. I have well over 5000 miles on my original set knock on wood. the only ones i have had to do so far is the rear end and after finally getting some stock ones again havent had to do it since after putting a new set of aftermarket ones every year for 3. the stockers have lasted another 2 years and are still going strong. steve

[lg440]

1st set, but i would suggest a kit from pivot works, they are as close to stock as i could find, i bought them and have been very pleased. for some reason i cant get the link to work but there is a kit on ebay item # 230483864564, apex-racing ebay store

[atv fan 28]

I like these.:D

http://www.atvbushings.com/

[levonskinator]

I know the stock ones would be the best but the money is just not there. atvfan, have you dealt with that company in the past cause they do look like a quality set of bushings.

[atv fan 28]

Originally posted by levonskinator
I know the stock ones would be the best but the money is just not there. atvfan, have you dealt with that company in the past cause they do look like a quality set of bushings. I have them on my 250R and they have held up very well.