Ride hight

[Foxstar45]

What are you all running for ride hight? I started at 50% of overal rear travel and now i'm at about 30%. I know i like it where it's at better but maybe i went too far. Just looking for simple 4'', 5'' 30%, 50% answers not, '' try different set-ups, and pick the one that works best for your riding style' type answers.
Thanks in advance.

[blaster99]

What kind of riding are you doing? try to get it down to 7 inches for mx. Have the front sit about 1/4 inch higher than the rear.

[bomberman]

the way i have it for mx is 7-7 1/2 on the rear and 7 1/2-8 inches on the front. And little bit higher if it wet or rutted out badly.

[Foxstar45]

Im riding MX. I think i have 10'' of travel total. When you say you have it set at 7.5'' does that mean that you would have 2.5 inches left in the travel?

[bomberman]

Im measuring from the floot to the bottom of the skid plate just in front of the foot peg. Then from the floor to the skid place a little bit in front of the nerf bar

[craigmacphee]

make sure when you measure this, you either have it on a really smooth garage floor, or piece of cardboard. You want to bounce it up and down a few times to get it to squat properly. If you did it on grass or gravel, it will not slide and will just lower and raise back up.