intake boot

[250rice]

does anyone know if a cr250r intake boot will bolt on to my esr cylinder and will my 38mm carb fit it as well iam pretty sure they have 38mm carbs on them from the factory i think it will fit i just dont know if they bolt up the same thanks

[matt250r21]

CR250 boots from 86-2001 will work on your cylinder. They are made to fit 38mm and up carbs. I've got an extra 2001 CR boot I will sell ya if you need one.

[250rice]

thanks for the info and sorry i dont like to buy stuff off of sites because i ripped off a lot i dont mean to offend i just dont like too unless you are in wv so i can pay in person thanks again

[jcs003]

what is different about a cr intake boot?

[slamdak8782]

I got a good way to make a stock one fit if you got one. Souds weird but boil it in water stick a coke bottle in it till it opens up and throw it in the freezer instant 39 mm carb fitter NO BS works like a champ

[Ruf Racing]

Originally posted by matt250r21
CR250 boots from 86-2001 will work on your cylinder. They are made to fit 38mm and up carbs. I've got an extra 2001 CR boot I will sell ya if you need one.

PM sent.

[spintly]

I run an ESR 310 kit and 38mm carb. I have an UPP intake boot on it and it works great!

http://www.uppracing.com/item.php?pid=232&cid=51

Hope this helps.

[tritty_wall]

Do you have to use a spacer plate with the CR boot? I got a ESR 350PV with v-force 3 reeds, 39mm PWK and the TRX intake boot seems a little long and makes a kink in my airbox boot. If I switch to a CR boot will this fix the kink? Thanks

[methyman]

It might fix it. The CR250 intake boot is shorter.

[tritty_wall]

matt250r21 do you still have the intake boot for sale? and how much? I thinking I'm going to give it a try. Thanks

[tritty_wall]

Does anyone use a intake boot like this? it looks like it would work good because you could cut it as short/long as you need, but one extra clamp for a air leak. thanks

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=290456294475&viewitem=&sspagename=STRK%3AMEWAX%3AIT

[matt250r21]

Sorry, CR250 boot is sold.

[2-330s]

cr boot is shorter,but it is also on a different angle. it turns the carb out towards the frame works fine just a little harder to get the carb on.

[tritty_wall]

I think I might just go with a boysen rad valve, I think it should get everything to fit good.