412yfzfanatic
05-25-2010, 06:24 AM
i rebuilt my motor with stage 2 cams high compression piston and put a new clutch in. but i over torqued a bolt thats in the oil line that runs from my crank to the jug. but my atv ran fine when i fired it up and held the throttle open. but cut out when i let go of the throttle. is this cuz of the oil? and i keep finding coolant in my oil and i replaced my gaskets. but i had to cut the tab on the head gasket where the exhaust flange meets the block. so it would sit flush. im abut to use rtv or yamabond. any fixes anyone can think of?