ran for 2 minutes shut off wont start

[sangheraent]

well i finished my build and i got the bike started i ran it for maybe 2 minutes at most at idle. it shut off on its own and i noticed some knocking so i drained the fuel i drained the bowl as well.and poured in some fresh gas at 32:1. and i cant get it to fire. plug comes out wet

I have a 38 a/s 50 pilot 180 main
89 bottom end 86 cylinder lrd mx port with spacer plate 86 piston
k&n filter
cr reeds
lrd pipe
170 compression
br8es plug

[oachs83]

Was the knocking like marbles in the engine? Do you have spark? if not you could have lost your CDI,coil, or stator. If you have spark what is your compression?

[heggie400ex]

FLYWHEEL KEY?

[sangheraent]

i got 170 compression tested after it wouldnt start. i dont mean knocking like stuff breaking i ment like pinging. but i will check the stator today.

[Grande Huevos]

not sure if this is your first R but they all have a slight ping sound that comes from the motor and it is normal could be the noise u hear? as for not starting most likely eletrical cdi, stator? also check the wire that goes into spark plug cap u might strip it back a little

[CODY_M11]

sangheraent

i had the same exact problem. i still had spark but was really weak.

so i got a new cdi and ignition coil and fired right up.

[oachs83]

What i meant by marbles is sometimes a real bad bing will sound like marbles rolling around. If you got pinging it most likely means the electrical could not keep up with the engine. If you have a book you can check the stator with a ohms meter. CDI and coil you just usually have to replace. There is a testing procedure for the coil but it still does not tell the whole story.