Fedor
05-19-2010, 01:09 PM
I was replacing the shims in my KFX 400 and the Dumb *** before didn't use to torque wrench to put the cam bolts in .............which in result caused one of the threads to break and come out with the bolt....
The picture below shows what bolt it is. I know there are somethings that I can use to rethread it but I know a lot of it doesn't hold for long into it becomes undone again. Any suggestions ? At this point this quad has been a pain and Im about to sell it soon.
Thanks
http://img28.imageshack.us/img28/8236/ltzenginebolt.jpg (http://img28.imageshack.us/i/ltzenginebolt.jpg/)
The picture below shows what bolt it is. I know there are somethings that I can use to rethread it but I know a lot of it doesn't hold for long into it becomes undone again. Any suggestions ? At this point this quad has been a pain and Im about to sell it soon.
Thanks
http://img28.imageshack.us/img28/8236/ltzenginebolt.jpg (http://img28.imageshack.us/i/ltzenginebolt.jpg/)