hjsmith00843
05-07-2010, 09:22 PM
I installed my stage 1 cam in today and when I fired it up it had no power. I would run but not very good at all.
I installed a sparks key so now I can not use the timing marks on the flywheel.
I did the screwdriver method and I am sure I had it at top dead center. But I can not be 100%. It stays at top dead center for just a a short time when turning the flywheel.
So what is the best option.
Remove the sparks key and put the stock one back in temp. and reinstall when I get it back together?
I installed a sparks key so now I can not use the timing marks on the flywheel.
I did the screwdriver method and I am sure I had it at top dead center. But I can not be 100%. It stays at top dead center for just a a short time when turning the flywheel.
So what is the best option.
Remove the sparks key and put the stock one back in temp. and reinstall when I get it back together?