Most common bolt on the 400ex?

[Impala400]

When i bought my 400EX it had no heel guards now i got some but i need to know the bolts for the pegs.

what size are the bolts that bolt into the bottom of the foot peg.
i would think that there are more bolts on the bike like this one

and the size of the one on the outter size. that screws to the peg and the plastic?

[Pappy]

not sure of the size....but it's part #90181-HN1-000 and it cost .94 cents from service honda. service honda (http://www.servicehonda.com)

[Pappy]

Originally posted by Pappy
not sure of the size....but it's part #90181-HN1-000 and it cost .94 cents from service honda. service honda (http://www.servicehonda.com)

actually thats the peg to frame bolt....but if ya look at the step/lever area on that site it will give ya all the info ya need....i hope it helps ya

[Impala400]

i don't have a close honda dealer so i was going to get them from my local hardware store, but if i have to i will get the parts from honda.

[JOEX]

#90181-HN1-000 = 10x45 according to Service Honda :)

Joe

[Impala400]

the most common bolt that i can think of is the 6mm ones that hold bolt to the frame for stupid odds and ends

[Rip_Tear]

2 suggestiongs... :D
1. Take one off from somewhere else and see if it fits? Dont force it
2. It really doesnt matter if there is no nut on the other side, mine didnt have one, so it just took one that would fit though the hole in the peg...

[Impala400]

thats exactly what i did.....:D and i put a nut so the screw would stay...i got all the nuts i need and more :)

[cheetah]

Originally posted by Impala400
the most common bolt that i can think of is the 6mm ones that hold bolt to the frame for stupid odds and ends

I thought they were 8mm:confused:

[muff]

Originally posted by cheetah
I thought they were 8mm:confused:

i think he might have been reffering to the thread size not the head size