Chain slider on roll design swingarm??

[YFZ_Racer42]

Right now I have two rollers, one big on the swingarm and one small under the pivot bolt, I was wondering if a eom style chain slider would fit there, I'm about to buy a tm design but wasn't sure if it would fit so I'm asking you!!

Thanks

[Jonny B]

There is a seller on ebay named bear81 that sells a nice chain slider. Type in "roll design chain" on ebay to find it. It goes in place of the big roller and wraps around the pivot area, the small roller is at any atv parts shop. This is what I have on my lobo now instead of the big wheel. You may need to trim a bit off the slider to get room for the chain between the small roller and slider, not a big deal.

[norcalduner]

What is wrong with the big roller ? I just stopped by Roll Design's shop last fall and bought a new one for $40.

[Jonny B]

Nothing wrong with the roller set up but the one I mention has no bearings to wear out and it wraps around the front of the swingarm pivot area adding extra protection...