Rear Engine Bolt/Swingarm

[racing12]

So after fighting the rear engine bolt/swing arm bolt for 2 hours, it finally came out.

Now I was removing the bearings and such inside that area of the swing arm and they wont budge, I don't see any C clips? Do they have to come out towards the middle of the arm or just out either side?

Just thought maybe I was over looking something.

Oh, and while I'm at it, any ideas on removing the balljoints on the a arms from the spindle? Just need to use a press or clamp?

[Balaz_73*00]

No cir clips on the bearings in the front of the swinger, you will probably have to have them pressed out. And I've used an automotive type balljoint fork to get the balljoints outa the spindle...couple taps and its out