greenskin77
04-28-2010, 10:06 PM
ok still same problem differnt day
my 250r powervale jug 330 is studdering at hig rpm and the main jet is 150 i belive i think its to lean but it works has a littil studder but not much
but the plug is still black but it is not wet like it was with the 175 mains
just black now
well i took the pipe off today and it has oil in it were it connects to the jug that is were the oil is not bad bulid up of oil but you can see it and it truns you finger black when u rub it
anyhow i did a pressure test and it held fine .
so
being a new ppv jug from esr they said it was ready to bolt on
BUT i wonder if i should hone out the cyl.. it looks ruff up still
any ideas has anyone delt with the esr ppv jug
thanks
my 250r powervale jug 330 is studdering at hig rpm and the main jet is 150 i belive i think its to lean but it works has a littil studder but not much
but the plug is still black but it is not wet like it was with the 175 mains
just black now
well i took the pipe off today and it has oil in it were it connects to the jug that is were the oil is not bad bulid up of oil but you can see it and it truns you finger black when u rub it
anyhow i did a pressure test and it held fine .
so
being a new ppv jug from esr they said it was ready to bolt on
BUT i wonder if i should hone out the cyl.. it looks ruff up still
any ideas has anyone delt with the esr ppv jug
thanks