jtpowell22
04-23-2010, 12:52 AM
1- Take 2 wires (blk w/red & wht w/red) from the stator and plug them directly into CDI box (same color wires)
2- CDI wires (plug orange and black) Run orange wire to hot lead on coil and ground the black wire
3- The black wire left on the CDI goes to a ground
4- Make sure to run ground from engine to frame
If you have an aftermarket Kill Switch- Run 1 lead to ground and other wire to hot lead on coil. Be careful not to run hot lead on coil to wire on killswitch that runs to the metal exposed part of the killswitch.
__________________
Ok here is the question. What wires need to be cut and stripped on the wire harness removal? I have located the wires for step 1. But #2 im not sure. Dont want to cut and strip wires if its not needed. I have lost spark for some reason and figured this may be the best cure.
Thanks
jp
2- CDI wires (plug orange and black) Run orange wire to hot lead on coil and ground the black wire
3- The black wire left on the CDI goes to a ground
4- Make sure to run ground from engine to frame
If you have an aftermarket Kill Switch- Run 1 lead to ground and other wire to hot lead on coil. Be careful not to run hot lead on coil to wire on killswitch that runs to the metal exposed part of the killswitch.
__________________
Ok here is the question. What wires need to be cut and stripped on the wire harness removal? I have located the wires for step 1. But #2 im not sure. Dont want to cut and strip wires if its not needed. I have lost spark for some reason and figured this may be the best cure.
Thanks
jp