MANIAK 88R
04-22-2010, 02:31 PM
Ok, I finally own my dream bike.... but a serious back injury has kept me from enjoying its full potential. I am getting a four stroke so I can have some bottom end to put put. I am getting a 2002 Houser CRF hybrid from a friend of mine. Before I can get it I have to part with my wife or my Laeger, and as much as I love my Laeger, the wife and my kids are more important to me. I'd like to get a feel for part buyers. Nearly all of the parts on my Laeger are perfect. I am not going to put prices on anything until I have enough parts spoken for. I may switch some parts between the Houser and the Laeger depending on which I like better. Here's a partial list.......
1996 Laeger chassis CR500 Narrow
(frame, swingarm, nerf package)
1996 Laeger T-pin +3 protrax arms chromed
(complete set up stem to spindles) stem PC,D orange
PEP limited mass long travel front shocks 180/200lbs
PEP CR500 rear shock 180/200lbs
Baldwin or Lonestar front hubs
Baldwin rear hubs
RPM axle
Billet bearing carrier.
A/C front / rear grab bars
ESR trx5 pipe/ silencer
(new silencer tip spark arrester)
ESR 350 PV cyl
(just back from esr w/new piston, plate, gaskets, o-rings)
ESR reeds
(i have two sets)
ESR billet stator cover-- blue
ESR kick starter -- blue
ESR air box eliminator kit
ESR brake / shifter blue
ESR temp gauge
CT Racing quick change clutch cover
(same as hinson)
Brand new Hinson Basket
Magura Hydraulic clutch
1989 bottom end with high output stator.
(comes with new ESR billet couter balancer plate)
I have a couple of ZING graphics kits.
I have a couple of sway bars
Some sets of beadlocks
38MM pwk
complete set of brakes
If you might be interested in any of these parts, please let me know. Once I get enough interest, I will make the descision to strip this thing. Thanks, MJ
1996 Laeger chassis CR500 Narrow
(frame, swingarm, nerf package)
1996 Laeger T-pin +3 protrax arms chromed
(complete set up stem to spindles) stem PC,D orange
PEP limited mass long travel front shocks 180/200lbs
PEP CR500 rear shock 180/200lbs
Baldwin or Lonestar front hubs
Baldwin rear hubs
RPM axle
Billet bearing carrier.
A/C front / rear grab bars
ESR trx5 pipe/ silencer
(new silencer tip spark arrester)
ESR 350 PV cyl
(just back from esr w/new piston, plate, gaskets, o-rings)
ESR reeds
(i have two sets)
ESR billet stator cover-- blue
ESR kick starter -- blue
ESR air box eliminator kit
ESR brake / shifter blue
ESR temp gauge
CT Racing quick change clutch cover
(same as hinson)
Brand new Hinson Basket
Magura Hydraulic clutch
1989 bottom end with high output stator.
(comes with new ESR billet couter balancer plate)
I have a couple of ZING graphics kits.
I have a couple of sway bars
Some sets of beadlocks
38MM pwk
complete set of brakes
If you might be interested in any of these parts, please let me know. Once I get enough interest, I will make the descision to strip this thing. Thanks, MJ