MR4Engine202
04-09-2010, 03:21 PM
I need to haul out the garage to make room for new toys...this is stuff that i have left over from wheelers ive had in the past and parted out. I will put up pictures as they are asked for. and please ask questions if you have any.
YFZ450
complete gasket kit only missing clutch
cover gasket-sold
coolant fan-$20
cutch perch, lever and cable-make offer
front hubs with rotors-$30
rear brake pedal the steel one-make offer
fender brackets-make offer
gas tank without petcock or cap-make offer
2006 rear shock-$45
front brake lines and center line-make offer
steering stem clamp with seals- make offer
thumb throttle with cable-make offer
air box with lid filter cage and intake
tube-make offer
seat with new seat cover never ridden on-$45
Raptor660
cam chain tensioner-$15
starter-$45
cases-$120
complete 2003 engine it has been completely gone through and rebuilt by a yamaha certified tech and was not put back into a frame...piston and cylinder specd out good but rings were replaced along with a completely new gasket kit, any bearings that were bad or questionable were replaced .....every piece of the engine was parts washed dried and re assembled using assembly lube and yamabond for the case halfs so all you have to do it put it in a frame and go This also will come with a few xtra's clutch plates, clutch cable, exhaust gaskets and any other things I have laying around-sold
YFZ450
complete gasket kit only missing clutch
cover gasket-sold
coolant fan-$20
cutch perch, lever and cable-make offer
front hubs with rotors-$30
rear brake pedal the steel one-make offer
fender brackets-make offer
gas tank without petcock or cap-make offer
2006 rear shock-$45
front brake lines and center line-make offer
steering stem clamp with seals- make offer
thumb throttle with cable-make offer
air box with lid filter cage and intake
tube-make offer
seat with new seat cover never ridden on-$45
Raptor660
cam chain tensioner-$15
starter-$45
cases-$120
complete 2003 engine it has been completely gone through and rebuilt by a yamaha certified tech and was not put back into a frame...piston and cylinder specd out good but rings were replaced along with a completely new gasket kit, any bearings that were bad or questionable were replaced .....every piece of the engine was parts washed dried and re assembled using assembly lube and yamabond for the case halfs so all you have to do it put it in a frame and go This also will come with a few xtra's clutch plates, clutch cable, exhaust gaskets and any other things I have laying around-sold