MR4Engine202
04-09-2010, 01:31 PM
I need to haul out the garage to make room for new toys...this is stuff that i have left over from wheelers ive had in the past and parted out. I will put up pictures as they are asked for. and please ask questions if you have any.
YFZ450
complete gasket kit only missing clutch
cover gasket-sold
coolant fan-$20
cutch perch, lever and cable-make offer
front hubs with rotors-$30
rear brake pedal the steel one-make offer
fender brackets-make offer
gas tank without petcock or cap-make offer
2006 rear shock-$45
front brake lines and center line-make offer
steering stem clamp with seals- make offer
thumb throttle with cable-make offer
air box with lid filter cage and intake
tube-make offer
seat with new seat cover never ridden on-$45
Raptor660
cam chain tensioner-$15
starter-$45
cases-$120
complete 2003 engine it has been completely gone through and rebuilt by a yamaha certified tech and was not put back into a frame...piston and cylinder specd out good but rings were replaced along with a completely new gasket kit, any bearings that were bad or questionable were replaced .....every piece of the engine was parts washed dried and re assembled using assembly lube and yamabond for the case halfs so all you have to do it put it in a frame and go This also will come with a few xtra's clutch plates, clutch cable, exhaust gaskets and any other things I have laying around-sold
Z400
complete 2004 engine....was a good strong running engine until the chain popped off and took out the left case half, everything is there it just needs a case half, also comes with radiator hoses thermostat, starter, reverse cable,clutch cable and any other xtras that i have for it-$550
2004 Bottom end same thing happened to this chain popped off it needs a left case half and does not come with clutch,clutch cover, or stator...but everything else is there and is all in still god working condition...just needs a case half-$120
2 sprocket hubs-$5ea.
oil lines-make offer
intake tube- make offer
shift lever-make offer
new axle bearing kit-$20
clutch cable and pitmant arm-make offer
reverse cable-make offer
2004 cylinder, needs honing-$20
oil pump-$15
front and rear sprockets-$15
stock a-arms-$75
spindles-$45
hubs-$40
home made grab-$5
ac std nerfs-$50
gas tank with cap and petcock-$25
air box with filter, cage, intake tubes and lid-$20
DVX headlight-$45
tie rods and ends-$20
carb with choke and throttle cable-$75
front brake master cylinder-make offer
valve cover with gasket-make offer
motor mounts- make offer
oil tank-$15
MISC. stuff
Warrior/raptor 350 rear shock bearing kit-$20
2 sets of shock bearing kits that fit 90-95 DR650SE
85-86 Lt250r
85-88 rm125/250
$15 ea.
YFZ450
complete gasket kit only missing clutch
cover gasket-sold
coolant fan-$20
cutch perch, lever and cable-make offer
front hubs with rotors-$30
rear brake pedal the steel one-make offer
fender brackets-make offer
gas tank without petcock or cap-make offer
2006 rear shock-$45
front brake lines and center line-make offer
steering stem clamp with seals- make offer
thumb throttle with cable-make offer
air box with lid filter cage and intake
tube-make offer
seat with new seat cover never ridden on-$45
Raptor660
cam chain tensioner-$15
starter-$45
cases-$120
complete 2003 engine it has been completely gone through and rebuilt by a yamaha certified tech and was not put back into a frame...piston and cylinder specd out good but rings were replaced along with a completely new gasket kit, any bearings that were bad or questionable were replaced .....every piece of the engine was parts washed dried and re assembled using assembly lube and yamabond for the case halfs so all you have to do it put it in a frame and go This also will come with a few xtra's clutch plates, clutch cable, exhaust gaskets and any other things I have laying around-sold
Z400
complete 2004 engine....was a good strong running engine until the chain popped off and took out the left case half, everything is there it just needs a case half, also comes with radiator hoses thermostat, starter, reverse cable,clutch cable and any other xtras that i have for it-$550
2004 Bottom end same thing happened to this chain popped off it needs a left case half and does not come with clutch,clutch cover, or stator...but everything else is there and is all in still god working condition...just needs a case half-$120
2 sprocket hubs-$5ea.
oil lines-make offer
intake tube- make offer
shift lever-make offer
new axle bearing kit-$20
clutch cable and pitmant arm-make offer
reverse cable-make offer
2004 cylinder, needs honing-$20
oil pump-$15
front and rear sprockets-$15
stock a-arms-$75
spindles-$45
hubs-$40
home made grab-$5
ac std nerfs-$50
gas tank with cap and petcock-$25
air box with filter, cage, intake tubes and lid-$20
DVX headlight-$45
tie rods and ends-$20
carb with choke and throttle cable-$75
front brake master cylinder-make offer
valve cover with gasket-make offer
motor mounts- make offer
oil tank-$15
MISC. stuff
Warrior/raptor 350 rear shock bearing kit-$20
2 sets of shock bearing kits that fit 90-95 DR650SE
85-86 Lt250r
85-88 rm125/250
$15 ea.