need some help cleaning up my bars

[ltrnutz43]

I wanna get all these wires off my bars,,,whats the wires runnin to the brake lever? how do i bypass the clutch safety switch? and what kind of start button/kill switch should i get to do away with the stock switch?

[panici33]

I believe the wire you're talkin about with the brake is to the brake light. You get get rid of that as well as everything on the left hand side, the blob as its called. Go to the yoshimura website and get the push starter button and the chock block off nut. This will get rid of the mess.

[muddy400EX]

is it hard to install the yoshi parts? i really wanna get the button and choke block

[panici33]

Nope. You literally just plug the starter button in where the old plugged into; it takes 10 minutes. The choke block off nut isn't difficult either. You just unscrew the cable that goes into the throttle body an replace it with the nut. There is a little spring that comes out with the cable; you still need this with the nut.

[ltrnutz43]

thanks

[ltrnutz43]

Hey Panic,,,,how do you get rid of the safety wire on the clutch perch?

[panici33]

can't remember, i will have to look at it tomorrow.

[panici33]

Originally posted by ltrnutz43
Hey Panic,,,,how do you get rid of the safety wire on the clutch perch?

I looked at it tonight and I am pretty sure i just unplugged it.

[ltrnutz43]

I was asking because I tried to unplug it and it made it so it wouldnt start, dead as a door nail...Gonna try and figure out how to bypass it

[hondaracer31]

connect the 2 wires together. It will think the clutch is always pulled in.

[panici33]

I didn't connect any wires. All i did was unplug it because i had the yoshi starter button. Just get the yoshi starter button and you won't have to do anything else.