Hood for fenders maier race cut ?

[cartman0102]

Hey,
I have a set of fenders maier.
The front is one piece. Race cut.
http://img188.imageshack.us/img188/3761/11723.jpg (http://img188.imageshack.us/i/11723.jpg/)

I want a hood as the QuadTech fourwerx or Mayer.

It is possible to install a nose on a front fenders in one piece?

Which model can adapt?

I've seen a nose fourwerx on front fenders fullbore which is in one piece.
http://img263.imageshack.us/img263/6210/0001496.jpg (http://img263.imageshack.us/i/0001496.jpg/)

I hope you understand me. Sorry for my very bad English.

Thank you in advance for your answers.

[danhung11]

That's a m a u l tech hood. They are made for full bore plastic. Those maier one piece are completely different design.

[ml250r]

i have a quad tech hood and was going to do the same w my maier race cuts. its easy to do. just thread the bolts in the hood (the quad tech has epoxied on mounts on the underside). then place it on your front where u want it, take a sharpie and mark where your bolts sit on the front end. drill your marked holes (might have to make the holes a little larger than the bolt for perfect alignment). Take a large washer and put on the bolt so it doesnt bury into your plastic and there ya go! DONE! hope that helps!