decomprssion

[fox400ex08]

just put my stage 1 hot cam is and i could not find the plunger or spring and i no it dident fall into the motor. where else could it of went besides the floor, im afraid to start it up with out nowing where it is, also what jets should i start it i got the stage 1 cam, lrd full pipe, knn filter open box

[3400ben]

Is this the first time someone rebuild it? The owner before you may have took it out. The spring and plunger don't come out on it's own.

[fox400ex08]

this is the first time i been into it sence i bout it bran new in 08

[fox400ex08]

took the valve cover off again to see if i could find it and there is nothing there i see the hole, is it down in the hole or does it stick out so the cam pushes it when it goes around, wanting some help wanting to go ride but done want to start it up if it fell in the motor

[3400ben]

The pin should stick out a little. The sping you will have to look in the hole. Take the clucth cover off. If it fell out it will be in the bottom.

[fox400ex08]

thanks i will take it off here in a while and let u guys no what i find

[fox400ex08]

took the clutch cover off and it wasent in the case or anywhere to be seen. and i no for sure it not in the hole where it should be

[fox400ex08]

dident find the plunger or spring anywhere tore the motor down lookin for it so it must of fell on the ground, started right up and its got more power to it now, just got to get my jetts right