View Full Version : wont run on.On...will only run on prime
dvx400rider04
02-27-2010, 04:13 PM
i rolled my quad and i fired it up and rode around and it wouldnt run on the on setting it would go but it cuts out everyoce in a while but on prime it runs fine and its been on that seting for almost a year of riding now its not urgent just wondering why weve cleaned carbs and stuff like that
cataway
02-27-2010, 07:13 PM
you could have a hole in a hose ,you could have a hose off ,there could be a hole in the diaphragm.
my self ,i would say get a raptor petcock
YOURADHERE
02-27-2010, 08:07 PM
Sounds like a vacuum line is disconnected.
Limited Z_400
02-28-2010, 08:47 AM
I would say possibly your vacuum line may be blocked or plugged.If you vacuum line was off your low idle would be way off (too fast)because it would be too lean.If that is ok check out your fuel cock assy.good luck
dvx400rider04
02-28-2010, 09:18 AM
k thanx ill check it out
jonboy
02-28-2010, 09:59 AM
Check you gas cap vent as well. Check to see if all the boots are tight and not torn. Like catawy state get a Craptor 660 petcock.
twincat800
02-28-2010, 10:09 AM
ive always just left mine on the primary posistion with my fcr39 carb and never have problems
Limited Z_400
02-28-2010, 10:29 AM
Raptor fuel cock assy. will bolt up to the Z tank good to know.
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.