ring gap??

[Stiles86]

need some info.... im puting a 13.5 je piston in my 08 ltr, when puting the rings on the piston what are you guys running for ring gaps, the cylinder is honed and i dont want to use the stock gapping i want to maximize compresion/power

[eastside 400]

there should of been a spec sheet with the piston, run what it says

[jerkyboy]

Gap it to the factory speck. If the cylinder is worn or honed ypu could have too much gap as it is. On the ltr's check the top of the cylinder for a wear ring about a 1/2" down from the top of the cylinder. If there is a slight grove id ge it replated or you will just
wear out those rings faster. Thats also just my opinion.

[Stiles86]

thanks guys