Need and Axis No-Link Shock 15-15.5"

[SilverLake250R]

There was just one on ebay and I went on today to get it and....of course...gone. So if anyone has one, let me know please. Thanks, Marc.

[badquad]

I might have one,, I need to measure it and take a picture of it. It also will need to be recharged again. The little 90 degree fitting that goes from the res. to the top of the shock has a crack so the oil leaked out. Other than that the shock is in great shape and looks good.

I will se if I can get a picture today.

[SilverLake250R]

That would be AWESOME if you did. hard to find. Thanks, Marc

[SilverLake250R]

Also, from more research, I think 15.5" to 16" would be fine...there is an old thread about this topic and it says 15-15.5 for stock frame with no-link swingarm, and 17.5 for no-link frame with no-link swingarm. Can anyone confirm the length needed for a stock frame? Thanks!

[badquad]

That sounds about right, I bought this shock for my LRD no Link frame, and Roll Design no link swing arm and it was to short. I do remember measuring it, and it was around 15, but let me double check tonight when I get off of work.

So I had to get another shock at 17.

But someone else can confirm this.

[Master LTR450]

R these eye to eye measurments or oversll?

[SilverLake250R]

Eye to eye. I called ROLL yesterday and Doug wasn't there. I'll try call them again tomorrow. By the way, I am still looking for a shock- in the $400 range. Thanks.

[SilverLake250R]

bump