JOEX
01-21-2003, 02:26 PM
I just received my bearing carrier and comparing it to the stock one, I noticed that there are no grooves for o-rings where the ends meet the swing arm openings. However there is a groove where the caliper bracket slides on but no o-ring.
Is this something to worry about?
Also, is this a "twin row"carrier? The actual width of the bearing surface (bearing race?) appears to be narrower than stock by a few millimeters.
I know, I should have asked these questions prior to purchasing...live and learn:(
Joe
Is this something to worry about?
Also, is this a "twin row"carrier? The actual width of the bearing surface (bearing race?) appears to be narrower than stock by a few millimeters.
I know, I should have asked these questions prior to purchasing...live and learn:(
Joe