Qs on 416 kit and rear hubs

[monster400ex]

ok i have a 99 400ex i just ordered a 416 kit i was wondering if i could use the stock cylinder sleeve or do i buy a la sleeve but they only makem in 89 mm bores and i have plus 3 a arms and a dura blue +4 axle but the front end in snow goes where ever i wants to go for the most part, how good are the g force hubs? any tips or help is greatly appreciated

[jdog75]

you can use the stock sleve and just get it bored and honed i just finished my 416 build over the weekend

[honda400ex2003]

the hubs are ok as long as you arent jumping with it. make sure they are tight like the stock hubs and you would be fine for a long time. I used the 1.5" each side for a long time and they worked great for trails and keeping it flat in the turns. X2 on the cylinder also. steve

[monster400ex]

yeah im goin to be racing mx so i need to be able to jump with it would the lonestar axle be any wider

[honda400ex2003]

it depends on how wide the lonestars are, you should have no trouble with a lonestar though. steve

[monster400ex]

iok never mind about the hubs my front rims are on backwards