No Link Question

[KYLE250R]

I HAVE A 89 250R,I WAS WOUNDERING IF I WOULD BE ABLE TO RUN A NO LINK SWING ARM WITH A STOCK FRAME OR DO YOU HAVE TO HAVE AN AFTERMARKET FRAME. WOULD I JUST NEED A NO LINK SWING ARM AN NO LINK SHOCK, IS IT A GOOD MOD OR IS THE PROLINK PRETTY GOOD. THANKS

[woodsracer144]

you can use a stock chassis there are 2 style of no links, a lobo style and a oe swinger style, i personally like the lobo style, i have a lonestar swinger, but if i had toget another on i would get a JRD, Herman, or a LOBO,
the Oe swinger style has a really sharp shock angle, you just have to have the shock set up for the chassis and the rear shock...

[Honda 250r 001]

so you buy any aftermarket no link swingarm? What length shock does this use?

[woodsracer144]

well people will say you will have to buy a no link swinger but you can use your OE one but your going to have to get the shock built for it...

theres 3 styles of them

1) the mount is below the rails
2) the mount is above the rails and in a OE location
3) the mout is above but is more towards the PB

[Honda 250r 001]

If i were to do it i would use a roll design gull wing style swingarm. would that use a 15 or 16 inch shock if you used the stock frame mounting location?

[woodsracer144]

im not sure, i'll go check...