Need Help! Plz!

[05zukzuk]

ok bike wnt start and im pretty sure its the valves, anyways getting to the point. can anyone maybe provide the steps for adjusting the valves?. i dnt have a manual for my bike and the one i ordered wont be here for a while and i need this bike to be running by the 15th. so plz any help is needed.

[knoxville9]

Remove the gas tank, the valve cover, the little circular cover on the left side of the motor and the smaller one above it. Under the bigger cover get a 17 mm socket put it on turn it counter clockwise. While looking into the smaller hole for a T its preatty small so watch for it, now get a fealer gauge and test the intakes to ensure that their 15 to 20 thousandths and the exhausts 20 to 30 thousandths if either are out of spec remove the cam chain tensioner on the right side of the motor. Remove which ever cam cap has the tight gapping and remove the cam take note of where the cam is set at. Then get a magnet and take off the chrome valve springs caps and get the shim beneath and when your done torque the cam caps to 89 inch pounds and the valve cover to 124 inch pounds

[wayne1ca]

Don't you mean mm for the valve clearance?
Which works out to .0039"-.0078" for intake
.0078"-.0118" for exhaust..

[knoxville9]

Well it looks like .020 on my feeler gauge for intake and .030 for exhaust and it always works but you could be right

[wayne1ca]

I got the info from the Clymer manual. Maybe its wrong.
Would like to know before I reassemble the one I am working on.

[knoxville9]

Are you sure your looking at the right clearances cause I have a clymer and it doesnt say that at all

[cataway]

harbor freight has the metric feeler gages ,it takes the so called guess work out of getting the right setting