PDA

View Full Version : Helpppp!!


honda01400ex
12-26-2009, 01:31 PM
I have a lock nut for my axel work open up i have done everything

a torch
torch then in cold water
vice and a pipe wrench


help
tri5ron
12-26-2009, 03:09 PM
make a mix of 50% ATF, and 50% Acetone.

This mixture actually works BETTER than WD-40, PB Blaster, Liquid Wrench, or Breakfree.

soak it with the 50/50 mix for a few hours, and tap it with a hammer to help break loose any rust in the threads. you should be able to get it loose then.
fishnfergie
12-26-2009, 08:14 PM
Its reverse thread....
togup
12-27-2009, 12:41 AM
Order a RAD nut when it comes in take a grinder with a cut off wheel and split the factory lock nut being careful not to go to deep , discard ,replace with Rad nut never have problems again
honda01400ex
12-27-2009, 12:40 PM
dont have money for rad lock nut im going to durhamtoen plantation tmorrow with friends and have to fix tonight! i have been spraying liquid wrench on it all day and tappin with hammer