jeremy_283
12-23-2009, 06:28 PM
I was gapping my piston rings from the bottom of my cylinder bore, the JE piston spec sheet said it had to have a minimum of .018" .... I got them to the minimum spec then I thought "oh, I should check them at the top of the bore" ...... they were at .022" at the top..... and at .022" in the middle..... Is this fine?
It's JE piston
It's on my KLR650...
thanks,
Jeremy
It's JE piston
It's on my KLR650...
thanks,
Jeremy