Firebird guys

[06 Honda 450R]

is all this stuff good?... it sounds like it but im not that into cars



2002 trans am, A4, 72k MILES
MODS:
TR 224/224 .563/.563 112lsa
hardened TR pushrods
tit. retainers
918 springs
LS1 Edit
double roller
TCI 3,500 2.5 stall
160* stat
Pacesetter LTs coated
Pacesetter ory pipe
SLP loudmouth w/3.5 tips
3in single cutouts
p/p stock TB
SLP lid
QA1 12 ways (4)w/ 325 springs
UMI weld on subframe connectors in the garage
UMI panhard adj.
UMI Lca's non adj.
UMI strut tower brace
MIDWEST fabbed 9"; strange alum center,drain,braced, detroit tru trac,31 spline axles moser,1/2" studs,tcs/abs,lca relocates, 3.70 gears
(new motive 3.89 gears in my garage)
Strange chromoly driveshaft
MIDWEST tourque arm/chromoly w/ shortened tunnel mount
3" 12mm studs for front
TCI line lock
B&M trans cooler
ZO6 replicas

thanks
WOULD LIKE TO SELL ASAP!!!

[ds268]

Yup that sounds like a well put together package. The most important stuff is done...suspension, especially the rear end. The cam is pretty tame, had it before but nice mid range power. The only thing I see that I would question is the comp cams 918 springs. They had casting flaws in their materials a while back but the "new" or updated springs are good. With that cam, they should be fine with those lift numbers. Its gonna be loud too with that exhaust system.

[06 Honda 450R]

would it be a nice fun car, and how much do you think its worth

[muddy400EX]

sounds like a pretty good build. ya it would definately be a fun car. id say 14-$15,000?

[ds268]

Still has factory heads, bottom end but even with the other mods I wouldn't give more than 12k. Its completely drivable and the only things I see that you will notice are road noise from the lower control arms unless they are poly bushings at both ends and the torque arm being tunnel mounted. Also the shocks; since those are primarily for drag strip useage its not going to be great for road trips but as far as drag shocks go... they are great. I didn't see anything for the fuel system but that's easily upgraded for a couple hundred bucks. At this point, it looks safe with the tune. That 9" rear will suck power but its worth the reliability factor. Probably pushing about 330rwhp and similar torque.

[trick450r]

Tiny little cam, Other than that it seems pretty well setup. That midwest chassis fab 9 inch is a masterpiece!

With that said, unless you have alot of patience I dont see you getting more than 11k out of her.

[trick450r]

also when you say ls1edit do you mean you bought the ls1edit software and tuned it yourself? because that's relatively impressive if it runs good.

[06 Honda 450R]

i saw this on craigs list, i really want a firebird but he wants 12500 for it