How to get clutch lift arm needle bearings out.

[Honda 250r 001]

Hey guys, i just bought a complete bearing kit and im trying to install it and i cant seem to get the bottom needle bearing out in the shift arm hole. Does anyone make a puller that will get that bearing out? Link?
Thanks

[machwon]

Motion Pro blind hole bearing puller $250, I have one and it's a handy tool. otherwise cut the race with a carbide bit and pry it out.

http://motionpro.com/motorcycle/tools/category/bearing_pullers/

[destey]

take an old screwdriver and grind it so you have a shelf basically. then clamp a vice grip on the metal screwdriver shaft near the handle. put the modified end down into the hole, get a grip on the side of the bearing with the screwdriver and wack up on the vice grips with a hammer. Its not pretty but it gets them out

[jcs003]

take it to the dealer and pay a few bucks to have them do. its not worth a damaged case if yu dont have the right tool.