setting internal clutch lever

[mycat8urskidoo]

Took the clutch cover off to make sure everything looked good, well for some reason i cant get my clutch lever (the one that goes inside the case) to work properly, I took it out to clean everything up and check the seal and bearing, and now i cant figure out how in the world to get it to grab the clutch haha, any tips?

[honda400ex2003]

you can try to spin it around each way a full turn to see if it will catch the right spot. i had to move mine around when i put it back on. steve

[sab24711]

the spring came loose or off you need to take your side case off.

[mycat8urskidoo]

covers already off, trying to figure out how to put it in there correctly so it'll grab right

[honda400ex2003]

turn it 90 degrees so the lever is facing out. i believe then you can slide it in and turn it back around to get it to hook, try it with the cover loose and see if you can get it to hook in there. you should be able to get it to hook in again, steve