revman
12-15-2009, 06:31 PM
Well tore apart my first whole bottom end new bearings and seals, new crank welded and trued, yz490 rod, yukon gears, neils clutch mod. now i just half to see if she will run...lol... It wasn't as bad as i thought it was going to be.
Oh and that is not the cylinder that will be staying on there. I just didnt want to experiment with a good cylinder just in case....well you know.
My question is if i decide to go an aftermarket big bore, i know the cases need to be bored but can i run a stock cylinder on bored cases, or does the skirt of the cylinder need the support from the case? The reason being is the cases that i used were already bored. For what i dont know. I was just thinking put a stock cylinder on there just to try it out and then go big. any input is much appreciated.
Oh and that is not the cylinder that will be staying on there. I just didnt want to experiment with a good cylinder just in case....well you know.
My question is if i decide to go an aftermarket big bore, i know the cases need to be bored but can i run a stock cylinder on bored cases, or does the skirt of the cylinder need the support from the case? The reason being is the cases that i used were already bored. For what i dont know. I was just thinking put a stock cylinder on there just to try it out and then go big. any input is much appreciated.