Parting restored 1989 LT250r... gotta go!

[fx4pitrone]

I'm parting out my restored 89 LT250r....Couldn't sell it whole and I need to fund my next 88 build (which will be faster and better and be Q-piped!)
I will let it go whole for $2000 whole or part it out. Here is a list of what it has:

COMPLETE MOTOR- $600 shipped, includes kicker, shifter, reedcage (and your very own Coleman $25 Ice Cube cooler for beer afterward!)
• Motor recently rebuilt (about a year ago by previous owner), crank bearings are good and tight... don't know bore
• No cracks/welds in engine cases… Original case saver and clutch cable holder in tact, motor is really in good shape
-No leaks, literally has less than hour on it since restore, always fired right up, shifted fine through all the gears, never a problem, but again, don't know what previous owner rebuilt and didn't, Motor was run w/ Maxima Castor 927 at 32:1 with 93 octane

Everything has less than one hour of ride time, and only on road and parking lot, never seen a trail since restore!

FRAME- $175
• 1987 frame-gusseted for durability *includes SB designs steering stem bushing, and pegs
• Was sandblasted, 2 coats primer, 4 coats of metallic candy blue, 5 coats of clear

Stock A-arms w/ fresh silver paint and clearcoat w/ ball joints and all brand new All Balls bearings and seals-$175

Front Hubs w/ rotors and brand new All balls bearings- $45
Front Brake Calipers: rebuilt and greased w/ new pads $75
Spindles $40
Tie-rods, painted silver w/ clear $35
Working Headlight w/ guard $40
Rear brake lever, painted silver w/ clearcoats $35
Front shocks $75
Rear shock $80
Rear hubs, painted candy blue w/ clear 5 lug $25
Newer FMF Fatty Pipe and silencer, $100
Brand new K&N air filter $30 Shipped
Brand New front (12) and rear (42) sprockets and chain $95
Brand New Tusk aluminum handlebars w/ Thor pad $25
Stock Carb w/ Brand new fuel lines (prob needs to be cleaned after sitting for a while now) w/ Polished aluminum OEM throttle and brand new Motion Pro throttle cable $100 Shipped
Brand new OEM wiring harness $25 Shipped
Brand new Kill Switch in Pkg. $20 Shipped
Brand new Longhorn clutch lever/perch, blue anodized w/ brand new motion pro cable $30 shipped
Brand New Braided Stainless steel brake lines, Front (w/ T-block) and rear $80 shipped
Brand New aluminum brake line clamps $25 shipped
Yellow OEM plastics off 92, no decals or cracks in rear, front has small crack along where nosepiece goes, has 92 camo graphics on front $200 for both
Blue hood, no cracks, has some holes drilled in it from previous owner $20
Front Holeshot XCT's 22x7x10, about 75% tread, w/ stock rims.. no plugs, hold air fine $90 pair
Rear grab bar w/ stock fender supports, and tail light, painted candy blue and cleared, $50
Swingarm w/ new Pivot Works bearings/seals and carrier (not new bearings), adj. plates were painted candy blue and cleared $175
Axle, straight $80
Airbox w/ lid and tubes (airbox has small burn hole from pipe) $35
Run, light, on/off switch $35
Motor mounts, painted silver and cleared, $25 shipped w/ stainless bolts


All prices w/o shipping unless it says w/ shipping...
I'm prob. forgetting stuff, so if you need something else, let me know... it's gotta go!!

[crazyjay]

do you have rear rims and tires, if so how much shipped

[fx4pitrone]

The rears I have are maxxis all-traks, 22".... on OEM rims. Tires have about 90-95% tread left (basically new), but one tire seems to have a slow leak...no plugs in it, and could not find source of leak.... rims are in good shape. I'd let them go cheap for the pair, but shipping would be kind of pricey... you could have them for $80 plus the ride

[crazyjay]

no thanks im not into the 22" thing.