Clutch Actuator lever bearing

[latheboy]

The clutch actuation arm on the left crankcase on my R seems to wobble around a lot. It is #6 in the fische. I wonder if I can replace the related bearings and seals, using a blind hole bearing puller? It sure seems like the bearing is shot. Let me know if any of you have run into this. It is loose enough that it will leak trans oil at times.

http://www.ronniesmailorder.com/fiche_image_popup.asp?fveh=3744&section=161814&year=1986&make=HONDA&category=ATVs&dc=2929&name=CRANKCASE

[86 Quad R]

i've ran into this quite some time ago. the upper bearing is the easy one but both can be removed with a blind bearing puller bur it has to be a small one tho. the lil needle bearings can make their way into the tranny and cause damage. as crazy as this sounds you may want to either flush the tranny area or split the cases to remove any that may have made its way in there.