Ryan
01-16-2003, 04:51 PM
I wrote a thread in here awhile ago about a bolt that I needed replaced (Near the idle, holding the throttle cable. I would order a new one but yamaha does not make this single piece :grr , I have to go out and buy the hole upper part of the carb ($110) just because of this small bolt.
The bolt is threaded on both sides and has a sleve on it which is welded to the bolt. If you have any idea of what I am talking about or any suggestions please let me know. I was thinking of putting 2 washers on each side to fit perfectly in the gap, but not sure if the bolt will still spin right :confused:
Im bad at explaining this crap. I try to get a picture somewhere of the web of this piece. BTW, Its a Yamaha Blaster.
The bolt is threaded on both sides and has a sleve on it which is welded to the bolt. If you have any idea of what I am talking about or any suggestions please let me know. I was thinking of putting 2 washers on each side to fit perfectly in the gap, but not sure if the bolt will still spin right :confused:
Im bad at explaining this crap. I try to get a picture somewhere of the web of this piece. BTW, Its a Yamaha Blaster.