ATV Four Play A-arms and hose issues

I have ATV FourPlay a-arms up from and am having a problem with the bottom hose from the radiator that goes to the bottom water pump inlet rubbing against the tie-rod...any suggestions? Pics of your setup? Thanks in advance!

[A.Kersey321]

Could you try cutting a little off the end of the hose then stretch it back to the radiator, this should pull it to be more straight.

[T@AFP]

You can roll the hose in towards the pivot points of the A arms too. This will allow you a little more clearance. It is a tight fit in there.

[JIM GRACE]

rubbings racing. lol i have seen them cut with an extension but
we leave ours alone and there fine. it would be sweet if cv4 would
come out with better ones and colors:devil:

[zach R 7x]

we ran FOUR PLAYS suspension this year and had no problems . i did cut a 1" hose in two and zipped tied it around that particular section of hose ,so it did not rub .