too low idle

[ridesa00400EX]

on my 400ex, it wont idle without dying. how to i make it have a higher idle? the rpm's are too low

[wheeltrax]

adjust the idle on the carb. turn it and it will make the engine rev a bit more to where it wont stall.

[KAWSAM62]

turn the idel screw clockwise to increase the idel its pn 11 on the pic good luck also set it when the engine is up to riding temp:macho

[YZROOSTINYA]

you also need to adjust the air fuel screw

its 14 on the pic

it explains it in the manual

the idle screw is the easiest though

[Steve-o 400EX]

The idle screw is actually big enough to turn with your fingers. I had to adjust mine after i put my pipe on.

[ridesa00400EX]

how long do you think it will take to do this?

[AtvMxRider]

about 10 seconds!

[Str8Wicked]

I had this same problem after throwing on my CT pipe. I would have to keep it revved high for the first min or so or it would die out. FInally I found the idle screw in my mechanics manual and found what an easy fix it was. I turned it up high first than lowered it little by little until I thought it was fine and would die out. It starts now with the first push of the buttona nd doesn't stall out a bit...

[jb400exxx]

when i put my pipe and stuff on and rejetted my idle was REALLY high. i had to adjust my throttle cable, and mess with the idle. but i fixed it. mine also fires up with just a push of the button and stays runnin.

[Str8Wicked]

I had this same problem after throwing on my CT pipe. I would have to keep it revved high for the first min or so or it would die out. FInally I found the idle screw in my mechanics manual and found what an easy fix it was. I turned it up high first than lowered it little by little until I thought it was fine and would die out. It starts now with the first push of the buttona nd doesn't stall out a bit...

[Syrus]

If you dont know how to make your quad idle faster or evern where it is you should stay far away from engines :p