moto xxx racer
10-11-2009, 03:30 PM
I have a 2002 400EX with a 440 Big Bore kit on it and a Lectron racing carb. My issue is that the Lectron carb and cable project higher than the stock carb. Thus putting an extreme angle on the throttle cable as it goes into the carb. I have put a couple of spacers to lift the tank up a little and the carb is offset to the right to clear the cable as much as I can under the tank. I am not happy with this set up. So here is my question. Is there a company that makes a intake spacer. That will give me some extra clearance, hopefully moving the carb towards the rear to clear the tank. Does any one else have this issue? Any help would be greatly apperciated. Thanks