jhtrx250r
10-05-2009, 01:30 PM
I am selling my superior sleeve 300 re sleeve motor or just the top end if that is all you want.
Here is a little more info:
cylinder was a stock 89, re sleeved to a 300 it has a fresh long rod piston 4hrs max 72.5mm bore has 2 bores left I was told.
I will put up pics showing the port work
The bottom end has flawless cases, good low hour gear set and clutch basket, new OE clutches and plates,New hot rod long rod crank, New bearings and seals apx 4hrs on the entire build.
(if your a local portlander the motor is still inthe quad and you can test it out if you like.)
pollished side cases with new water pump (rebuilt)
no stator
asking $1000 shipped (in the lower 48 of the US) for the motor add up all the parts and the work done and thats a deal.
I would sell just the top end for $375 with new gaskets
This motor dyned (I was told by previous owner) at 52hp at the rear wheels
My CPI 310 PV Dynoed at 53hp at the wheels and this one seems around the same, but pulls way harder than the CPi off the bottom.
It was ported for dunes/MX but I rode it in the woods and it worked great.
Here is a little more info:
cylinder was a stock 89, re sleeved to a 300 it has a fresh long rod piston 4hrs max 72.5mm bore has 2 bores left I was told.
I will put up pics showing the port work
The bottom end has flawless cases, good low hour gear set and clutch basket, new OE clutches and plates,New hot rod long rod crank, New bearings and seals apx 4hrs on the entire build.
(if your a local portlander the motor is still inthe quad and you can test it out if you like.)
pollished side cases with new water pump (rebuilt)
no stator
asking $1000 shipped (in the lower 48 of the US) for the motor add up all the parts and the work done and thats a deal.
I would sell just the top end for $375 with new gaskets
This motor dyned (I was told by previous owner) at 52hp at the rear wheels
My CPI 310 PV Dynoed at 53hp at the wheels and this one seems around the same, but pulls way harder than the CPi off the bottom.
It was ported for dunes/MX but I rode it in the woods and it worked great.