xrxmxcx
09-12-2009, 11:05 PM
After tearing down the bike again, were putting it back together using the X MX package parts that are offered in the racer program. Setting the front end up going by the suggested settings for camber/caster, but does anyone have any input?
This year I have been running the Walsh Flow to the standard spec's and fine tuned down to where it handles perfect. Looking to set this bike up to ride some production classes next year. As far as rear end rear shock setup and axle width are pretty straightforward, but I found running 1 spacer on the outside made the bike a bit more manageable on the tight tracks.
Just looking for a little comparison...
This year I have been running the Walsh Flow to the standard spec's and fine tuned down to where it handles perfect. Looking to set this bike up to ride some production classes next year. As far as rear end rear shock setup and axle width are pretty straightforward, but I found running 1 spacer on the outside made the bike a bit more manageable on the tight tracks.
Just looking for a little comparison...