2009 yfz450r dirt bike kill switch start button

[duffman1483]

I have a 2009 yamaha yfz450r and was going to wire a dirt bike kill switch for where the headlight switch used to be. I did this on the 400ex before but there is a lot of sensors and I just want to be sure I have all the info before I start digging in. If I were to wire it up, is there any other wires I have to worry about, does the clutch position sensor have to be wired in to anything? Any help is very appreciated.
Thanks,
Ken

[hendershot106]

i just took the wires from the clutch position sensor and traced under the hood.... unhooked the harness plug in from it and pigtailed the two wires together and plugged back into the harness... as for the kill switch start button.... thats an easy one.. just take apart the stock switch... see what color wires make contact at the stock start button... trace them.. attach your yz style kill switch button to them... and cut off the rest... again.. you can just use the harness plug in that goes to the stock headlight./start switch.

[daddio]

You would also have to hard wire your on/off switch wires together.

Fly makes a real nice, waterproof, billet alm. start switch.

[hendershot106]

Originally posted by daddio
You would also have to hard wire your on/off switch wires together.

Fly makes a real nice, waterproof, billet alm. start switch.

...yep ... forgot to tell him that one....my bad...

[duffman1483]

thanks for the help guys