PDA

View Full Version : Drill the bottom spindle



Juha_Kankkunen
08-29-2009, 02:12 PM
Time ago i bought a set of Blaster a-arms, and now i need to drill the spindles for mout then on the atv.

Where can i do it?. I can't send them to Burgard because i'm not fromthe USA, i'm from Europe.

Thanks.

burgard rep
09-06-2009, 07:29 PM
can you get snap on tools in Europe?

Juha_Kankkunen
10-07-2009, 03:27 AM
The problem is that i bought the arms the past year, and when them arrived and i noticed they don't fit properly i contacted you in order to send them again to you paying i the shipping costs.

I can't find a site to do that modification. I think is not very complicated, but i can't find it and i have the arms since last October at home on the garage, and can't sell them because of the problem of the spindles.

That's the problem. The arms are not used, only were mounted one time. I will have to eat them...

burgard rep
10-12-2009, 10:02 AM
Snap On tools are available in Europe. There is a location in Spain. The part you need is a 1/2'' to 1'' Tapered Ream. The part number here is R121.