flexx bar ?

[Jessem24]

a friend of mine has flexx bars on his raptor 700. he has a clutch perch, handguards and the odi lock grips. but there is no room left on either side. were the heck would you put a teather? i wanted a set of these bars but this is holdn me back:ermm:

[Scro]

They make bar clamps that have the tether mounts made into it. Or, if you get the wide Flexx bars, the Prodesign will fit right next to the bar clamp if you sand the tether down just a bit. He may just have the narrow bars.

when i had my flexx bars..i had odi grips, powermadds, a starter button and my tether, as well as my clutch perch all on the left side all on

when i got rid of the 450r and went back to a 400ex, all fit on again because everything was the same

[RideRaceLive93]

hey jesse your johnny bud right?? well any way where you bount the bar clamps the 1 1/8 inch part there is room for the pro armour teaher its clean and out of the way

[RideRaceLive93]

oh and being the short dude you are get a 14 degree bend you sit far enough up i run 12 degree but im 5 10-11 and i can get most my weight on the front tire when corning

[TRX450RACER174]

Its kind of hard to see but my kill switch is mounted
on the center tube in front of the clamp.
If you look at the pic next to the key switch you can see it mounted on the bars.
http://i276.photobucket.com/albums/kk10/TRX450RACER174/TRX450ER016.jpg
Here is a closer pic.
http://i276.photobucket.com/albums/kk10/TRX450RACER174/TRX450ER014.jpg

[Jessem24]

thanks guys