IcutMetl
08-16-2009, 02:31 PM
I'm attempting to get rid of my 38PJ and MotionPro "turbo" twist throttle/cable setup. Going to a 38 air stryker and a Motion Pro "CR PRO" twist.
If any of you have had experience with both these carbs, I'd like to hear your opinions. The 38PJ was on my 'wheeler when I bought it.
So far, my motor has about 4 tanks of gas thru a fresh 67.5mm Wiseco piston, midrange ported, RAD Valve, thin head gasket w/ approx 195-200psi compression, running 50/50 mix of premium pump and CAM2 110. Mix at 40:1 Klotz super techniplate. FMF Fatty pipe and FMF silencer. With my 38PJ, I had the best luck with a 175 main, 48 pilot, and a DGH on the 4th clip. I'm running the stock airbox with snorkel, UNI filter with holes in the lid. It seems to have fair low end, and a really broad powerband...which I like. The plug burns a medium brown and never fouls.
I've read a lot about these 'wheelers, and it seems like the 38 airstryker is the all-around hot ticket. I ride mainly XC type terrain, in all situations, and will be going big bore down the road a few.
Also, if any of you would know which Motion Pro cable to use with a "CR Pro" throttle and this carb, please fill me in!!
Thanks for the help!!
If any of you have had experience with both these carbs, I'd like to hear your opinions. The 38PJ was on my 'wheeler when I bought it.
So far, my motor has about 4 tanks of gas thru a fresh 67.5mm Wiseco piston, midrange ported, RAD Valve, thin head gasket w/ approx 195-200psi compression, running 50/50 mix of premium pump and CAM2 110. Mix at 40:1 Klotz super techniplate. FMF Fatty pipe and FMF silencer. With my 38PJ, I had the best luck with a 175 main, 48 pilot, and a DGH on the 4th clip. I'm running the stock airbox with snorkel, UNI filter with holes in the lid. It seems to have fair low end, and a really broad powerband...which I like. The plug burns a medium brown and never fouls.
I've read a lot about these 'wheelers, and it seems like the 38 airstryker is the all-around hot ticket. I ride mainly XC type terrain, in all situations, and will be going big bore down the road a few.
Also, if any of you would know which Motion Pro cable to use with a "CR Pro" throttle and this carb, please fill me in!!
Thanks for the help!!