Melton69
08-15-2009, 10:44 AM
Hello all, I am getting ready to send of my 86 250R frame, swing arm, a-arms, steering stem, etc. to get powder coated. Just about every part that could get powder coated is. I was hoping I could get some input on places where I should mask off.
Also, is it important to put bolts in the threads on parts to keep paint from getting in there?
Thank you for any help,
-Melton
Also, is it important to put bolts in the threads on parts to keep paint from getting in there?
Thank you for any help,
-Melton