quick front end question

[rigger]

quick question on the front end.

when setting up everything on the front end as far as toe and caster and camber, you should or should not do it with the machine on the ground and the front end with some weight on it?

I am just assuming that it should be done on the ground with weight on it.

Please correct me if I am wrong.

[knobbyboy]

I think if you do it up in the air you'll be doing it again once it hits the floor. IDK - this whole process is tough and always takes me much longer than I think it will.

[ZSNOW]

do it on the floor with the rider in position for measurements, then put it up in the air for adjustment, then back down with the rider in position for measurement..

but to get ride height have a friend pick up on the front of the quad to pull the suspension up to full extension, then when the friend lets go turn the handlebars, left, right,left, straight and you'll be at ride hieght.