cjm8232
08-05-2009, 07:18 AM
I am finally getting into the repairs I need to make to my 250x...The rear wheels locked up a couple weeks ago. I am taking out the bearing carrier, as I suspect all my problems are there.
Do I need to replace the C-Clip that is on the axle? Or should I be careful when removing it and try and re-use it?
I destroyed the cotter pins when removing the rear wheels, where do I get the correct cotter pins?
Do you guys torque everything back up with a torque wrench?
Are there any other pins or clips or anything that should be replaced at this time while I have the bearing carrier out?
Do I need to replace the C-Clip that is on the axle? Or should I be careful when removing it and try and re-use it?
I destroyed the cotter pins when removing the rear wheels, where do I get the correct cotter pins?
Do you guys torque everything back up with a torque wrench?
Are there any other pins or clips or anything that should be replaced at this time while I have the bearing carrier out?